Too thin or leakage, adjust the amount of mud into the mud; adjust the height of the sludge evenly distributed; adjust the size of the cylinder tensioning pressure, too thin or side leakage to reduce the cylinder tension.

Check the bearing is lack of oil, such as missing please add grease; If the bearing is damaged, please replace the bearing (first loosen the shaft head back only within the screw, turn off the bearing bolts for replacement);

Check whether the air intake valve on the cylinder to adjust the balance; whether the gas leak; cylinder is malfunctioning. If the intake air is unbalanced, adjust the intake pressure and adjust the cylinder in and out of the valve to balance; if the trachea and fittings leak, recalibrate, if damaged, replace; if the cylinder fails, replace or repair.

School bias stick fixed locking parts are loose, such as loose with a wrench lock; fixed small roller outside the retainer is off, such as shedding re-tighten.

(1) thickener drum wheel is installed or worn properly, such as offset adjustment of the installation location, such as wear and tear to replace, adjust and replace the roller when lifting the drum, remove the wheel to adjust or replace, and then down Drum(2). If the thickener drum string move, friction thickener before and after the fixed frame, loose thickener bearing lock sleeve, adjust the drum, and then lock the bearing and the shaft connection locking sleeve.

(1) The dehydrator control box power switch and air compressor work, but the entire machine can not work to see whether the pressure switch is intact or wiring is a problem, such as the pressure switch failure to replace the pressure switch;(2). Fuse is intact, such as burned, check the pressure switch is short circuit, micro switch is short circuit, if any, please replace the replacement steps as described above.More than ten points is only a common dehydration machine failure, I hope everyone in the boot before we have to carefully view the company's dehydration machine operating manual, if there are outstanding matters, please call the inquiry.